Ruckus AP CLI commands --

 Ruckus AP CLI commands 

-->>  remote ap-cli <AP-MAC-Address> “AP CLI command”

Use remote ap-cli command to execute AP CLI commands remotely from SCG

-->> get scg

-Use get scg to display SCG Settings

-->> set scg ip “IP Address” 

-Use set scg ip to set the IP Address of the control interface.

-->> get director

-Use get director to show ZoneDirector information.

-->> set director ip “IP Address”

-Use set director to set ZoneDirector options. Reboot is required for changes to take effect.'

-->> ping

-Use the ping command to attempt to ping another station

-->> traceroute

-Use the traceroute command to conduct a traceroute test.

-->>get version

-Use get version to display the software version running on the AP.

-->> get uptime

-Use get uptime to display how long the Ruckus Wireless device has been running.

-->> sysinfo

-Use sysinfo to get CPU and memory utilization information.

-->>get ap-mode

-Use get ap-mode to display AP operation mode (standalone or managed mode).

-->> get boarddata

-Use get boarddata to display hardware version and system board information.

-->> support

-Use support to generate support log information.

-->> support show

-Use support sho to show support log information

-->> fw show all

-Use fw show all to display firmware

-->> get tunnelmgr

-Use get tunnelmgr command to display tunnelmgr settings.

-->> get wlanlist

-Use get wlanlist to display a list of all WLAN interfaces. If the AP is a dual radio

AP, the RadioID column indicates which radio (2.4GHz or 5GHz) is serving the WLAN.

-->> get wlaninfo

-Use get wlaninfo to list all configured wlan interfaces and security settings

-->> get channel <wlan name>

-Use get channel to display the transmit channel on the device.

-->> get state <wlan name>

-Use get state to display the state of a WLAN interface.

-->> set state <wlan name> {up|down}

-Use set state to configure the state of a WLAN interface.

-->> get station <wlan name> list

-Use get station to get station list, information and statistics.

-->> get mqstats <wlan name> all

-Use get mqstats to display Media Queue Statistics

-->> get rpki-cert {issuer|subject|validity}

-Use get rpki-cert to display AP certificate information

-->> reboot

-Use reboot to restart the AP.

-->> set factory

-Use set factory to return all configuration settings to their factory defaults.

To do a remote packet with for example Wireshark you can use the following commands:

-->> set capture wlan100 stream

– This sets up packet capture on 2.4GHz radio

-->> get capture wlan100 state

– This displays status of 2.4GHz radio capture

-->> set capture wlan100 idle

– To stop the capture on 2.4GHz radio

-->> set capture wlan101 stream

– This sets up packet capture on 5GHz radio

-->> get capture wlan101 state

– This displays status of 5GHz radio capture

-->> set capture wlan101 idle

– To stop the capture on 5GHz radio